INFICON Protec P3000(XL) Helium Leak Detector - Manual (Page 4)

0-4
Content
k
in
a
26
eI
V
Z
.f
m
Tech
ni
ca
l Ha
nd
bo
ok
(1
20
9)
3.5 Calibration and Self-Test 3-15
3.5.1 Verifying a calibration (proof function) 3-15
3.5.2 Internal calibration 3-17
3.5.3 External calibration 3-17
3.6 Standby 3-20
3.7 Shutdown 3-20
3.8 Storage for fast availability as back-up unit 3-20
4 Equipment Settings 4-1
4.1 Menu Structure 4-1
4.2 The Service Menu 4-3
4.3 Selecting gas equivalents and setting trigger values 4-3
4.3.1 Setting gas parameters 4-3
4.3.2 Selecting a set of gas parameters 4-7
4.4 Settings Sub-menu 4-8
4.4.1 Vacuum & Access 4-8
4.4.2 Audio Functions 4-15
4.4.3 Display Settings 4-17
4.4.4 Setting-up / editing an I•Guide Program 4-19
4.4.5 Miscellaneous Settings 4-21
4.5 Interfaces 4-23
4.5.1 Control location 4-23
4.5.2 Recorder outputs 4-23
4.5.3 RS232 Protocol 4-25
4.5.4 Select PLC inputs 4-27
4.5.5 Baud rate & end sign 4-27
4.5.6 PRO-Check (only available in advanced mode) 4-27
4.6 The Info Menu 4-28
4.7 History & Maintenance 4-32
5 Protec P3000 Messages 5-1
5.1 Error Messages and Warnings 5-1
6 Equipment Connections 6-1
6.1 I/O Port (Control Inputs and Outputs) 6-1
6.1.1 Ground connectors 6-2
6.1.2 24V Output 6-2
6.1.3 PLC Inputs 6-2
6.1.4 PLC Outputs 6-3
6.1.4.1 Relay outputs 6-5
6.1.4.2 Recorder Outputs 6-5
6.1.5 How to perform a calibration? 6-6
6.2 RS232 interface 6-7
7 Maintenance 7-1
7.1 Maintenance schedule 7-1
7.2 Exchanging the air filter 7-2
7.3 Exchanging the external fuses 7-4