INFICON Protec P3000(XL) Helium Leak Detector - Manual (Page 73)

Equipment Settings
4-18
k
in
a
26
e Ch
ap
te
r
4
.fm
Tech
ni
ca
l Ha
nd
bo
ok
(1
20
9)
Flow display (only available
in
ADVANCED mode)
In the FLOW DISPLAY submenu the continuous display of the flow through the sniffer
line during measurements can be ENABLED or DISABLED . If ENABLED , the flow will be
indicated in the STANDARD OPERATION MODE only underneath the leak rate bar graph
as integer number.
Notice After certain events like acknowledging warnings or when switching the
flow mode, the flow monitoring may be disabled for a short period of time
while the flow stabilizes to a final value again and no new warnings will be
issued. During this time a message ”Flow control inactive” will be displayed
instead of the flow value.
Default setting: disabled
User mode
In this submenu either the NORMAL or the ADVANCED mode can be selected. In the
NORMAL mode only the most relevant information for normal operation will be
displayed whereas in the ADVANCED mode additional information for advanced users
will become available.
Fig. 4-16 Setting-up the peak hold function