230v, Ab l1 l2 – Flint & Walling CPJS Shallow Well User Manual
Page 18
18
PUMP ELECTRICAL CONNECTIONS
To change from 115V to 230V
11. The motor of this pump is dual voltage and can run
on either 115V or 230V. In general, 230V is more
economical to run, and requires a smaller wire size.
Most models are factory preset to run at 115V.
NOTE: See pump label to verify voltage prewired at
the factory. (
Fig. 11)
12. For 230V service, change the following wires on the
terminal board:
a. Using a pair of needle nose pliers, pull the gray
wire with the female flag connector from the “A”
terminal spade post. Place it to the right on the
“B” terminal space post. (
Fig. 12a)
b. Pull the red wire with the female flag connector
from the “L2” terminal. Place it to the left on the
“B” terminal space post. (
Fig. 12b)
A
B
L1
L2
IL1355
GRAY
RED
12a
A
B
L1
L2
IL1356
230V
GRAY
RED
12b
c. Reinstall the rear motor cover. (
Fig. 12)
NOTE: To change models from 230V to 115V, simply
reverse instructions above.
12c
S
TAR
®
C
US
LR90197
UL Std. No. 778
ENCLOSURE 3
starwatersystems.com
Pump:
ES05S
Rev:
B
Motor:
98L105
HP:
1/2
PH
1
Hz
60
Volts
115/230
S.F.
1.2
Amps
6.4/3.2
S.F. Amps:
8.6/4.3
RPM
3450
Type
C
Duty:
Cont.
Temp
65C
KVA Code
G
Frame
56L
Ins Class
B
Factory prewired for 115V
Thermally protected automatic
Check voltage of power source
Use copper conductors only
ELECTRICAL HAZARD
Improper installation may result in fi re, explosion, electrical short or injury. Replace all covers
before operating. Ground motor in accordance with local and national electrical codes.
Disconnect power source before touching internal parts. Motors equipped with automatic
protection may restart without warning.
See instruction manual for proper installation procedure.
Se reporter au manuel d’instructions pour suivre la procédure adéquate d’installation.
Consulte el instructive para conocer el procedimiento de instalación correcto.
L1
L2
A
B
L1
L2
A
B
IL0180
YELLOW
115 VOLT
SINGLE PHASE
LINE
230 VOLT
SINGLE PHASE
LINE
WHITE
GRAY
RED
TAN
YELLOW
WHITE
GRAY
RED
TAN
DATE CODE:
0713*
Made in USA
11