Flint & Walling CPJS Shallow Well - Manual (Page 17)

17
7. Insert an electrical wire strain relief into the opening in
the opposite side of the pressure switch. ( Fig. 7)
IL1376
Wire from
motor
Pressure
Switch
Strain
Relief
7
Wire from
motor
Wire from
power
supply
8
Wire from
motor
Wire from
power
supply
Outside
terminal
Outside
terminal
9
Wire
from
motor
Wire from
power
supply
Ground Screws 10 10. Connect the green ground wire from the power
supply to the remaining green ground screw in the
pressure switch and re-attach the pressure switch
cover. ( Fig. 10)
9. Connect the two wires from the power supply to the
two outside terminals on the pressure switch. ( Fig. 9)
8. Thread the cable from the power supply through the
strain relief and tighten both screws on the strain relief.
Do not crush wire. ( Fig. 8)
PUMP ELECTRICAL CONNECTIONS