System reset to factory settings – EUCHNER MGB-LxxB-PNx-xxx (PROFINET) with Data Structure Type B User Manual
Page 25
Operating Instructions Safety System MGB-L..B-PN.-... (PROFINET)
25
Replacement of an MGB system without program-
ming device
If servicing is required, the MGB system is easy to replace with a new one. For this
purpose, the following prerequisites must be met:
ÌThe DIPswitch settings (PROFIsafe address) of the new device must match
those of the old device.
ÌYour Profinet master must support the automatic replacement of Profinet sub-
scribers.
ÌYour Profinet topology must be correctly configured.
ÌThe replacement device must be connected to the same port as its predeces-
sor.
ÌThere must be no device name in the MGB system.
This field is empty in the as-delivered state. Systems that already contain a
name must first be reset to the factory settings.
Once these conditions are met, simply replace the old system with the new system.
The Profinet bus does not need to be switched off for this purpose.
System reset to factory settings
You will find detailed instructions in the manual for the configuration software for
your control system.