ETC Unison Paradigm Wireless Access Station - Manual (Page 4)

E T C I n s t a l l a t i o n G u i d e
Unison Paradigm Series
Unison Paradigm Wireless Access Station Page 4 of 4 Electronic Theatre Controls, Inc.
Step 2: If needed, fold the receptacle spacer in an accordion fashion and press
together to achieve the required thickness to fill the gap between the station
and the flush mounted backbox.Discard the unused spacers.
Step 3: Secure the station to the backbox with the four screws provided in the
installation kit. If using spacers, insert the screws through the spacers as well.
Power Up Indicators
Installing the Faceplate and Antenna
The faceplate is secured to the station with two magnets that are located on the bottom
side of the faceplate.
Step 4: Swing the bottom of the faceplate down until the magnets engage.
Step 5: If the faceplate does not fully attach automatically, wiggle the bottom of the
faceplate until the magnets are seated properly to the station and the faceplate
is secure.
Step 6: Reattach the antenna to the station receptacle. The antenna should be
directed upward when installed properly.
N o t e : This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Buttons and indicators are located on the station electronics.
RESET (button): resets the station and cycles the power
SERVICE PIN (button): sends station service pin to the Paradigm ACP
LON SVC LED: indicates that the service pin is transmitting
LON Data (LED): indicates station bus activity
RADIO TX DATA (LED): indicates the radio is transmitting data
RADIO RX DATA (LED): indicates the radio is receiving data
POWER (LED): indicates the station is powered
Step 1: Remove the antenna from the
electronics assembly.
Step 2: Align the top of the faceplate
approximately 20 degrees from the
station.
Step 3: Hook the top of the faceplate to the
tabs located on the station
electronics assembly. To ensure the
faceplate is hooked properly on the
top hook, wiggle it slightly side to
side while the bottom is angled
about 20 degrees from the wall.