Enerpac PL-Series - Manual (Page 3)

MOUNTING SPECIFICATIONS
Mounting Threaded Body Cylinders
Threaded body cylinders can be threaded into a tapped hole, secured to the fixture using
a mounting flange, threaded into the fixture and secured with a jam nut, or mounted
through a clearance hole and secured with jam nuts. See illustrations below.
When a threaded body pull cylinder is being installed in a fixture, the thread engagement
should be no less than the thread engagement for the standard Enerpac mounting flange.
If a cylinder is being mounted using just the lower portion of the threads, the engagement
should be increased for additional support. See table below for minimum thread
engagement.
Cylinder Capacity Minimum Thread Engagement
2,2 kN 500 lb 13 mm .50"
5,6 kN 1250 lb 13 mm .50"
9 kN 2000 lb 16 mm .63"
35 kN 7900 lb 30 mm 1.25"
oil connection
jam nut
threaded into fixture
mounting flange
oil connection
jam nuts
Figure 1
3