Enerpac WST-72 - Manual

L2110 Rev. B 01/98
IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. If any shipping damage is found,
notify carrier at once. Shipping damage is NOT covered by warranty. The carrier is
responsible for all repair or replacement cost resulting from damage in shipment.
SAFETY INFORMATION
To avoid personal injury or property damage during system operation, read and follow
all CAUTIONS, WARNINGS, and INSTRUCTIONS, included with or attached to each
product. ENPERPAC CANNOT BE RESPONSIBLE FOR DAMAGE OR INJURY
RESULTING FROM UNSAFE USE OF PRODUCT, LACK OF MAINTENANCE, OR
INCORRECT PRODUCT AND SYSTEM APPLICATION. Contact Enerpac when in
doubt as to safety precautions or applications.
=
WARNING
Always wear proper personal protective gear when operating hydraulic equipment
(i.e. safety glasses, gloves, etc.).
=
WARNING
The system operating pressure must not exceed the pressure rating of the lowest
rated component in the system.
=
WARNING
Make sure that all system components are protected from external sources of
damage, such as excessive heat, flame, moving machine parts, sharp edges, and
corrosive chemicals.
=
WARNING
Do not exceed the specified maximum load on the support plunger.
=
CAUTION
AVOID DAMAGING HYDRAULIC HOSES.
– Avoid sharp bends and kinks when routing hydraulic
hoses. Using a bent or kinked hose will cause severe
back–pressure. Also, sharp bends and kinks will
internally damage the hose leading to premature failure.
– Do not drop heavy objects on hose. A sharp impact may
cause internal damage to hose wire strands. Applying
pressure to a damaged hose may cause it to rupture.
TO PROTECT YOUR WARRANTY, USE ONLY ENERPAC HYDRAULIC OIL.
®
Instruction Sheet
Fluid Advanced and
Spring Advanced Worksupports