Despatch LCC/LCD2-14-3 Non Pass Through Series - Manual (Page 69)

60
Quick Reference and Default Values
Program Page
Menu Item Display Default Range Setting
Ramp Time Seg 1 Pro-1 Seg-1 Ramp Time 00:00 00m00s to
99h59s
Event 1 Set Value Pro-1 Seg-1 Ramp Event 1 Off Off, On
Event 2 Set Value Pro-1 Seg-1 Ramp Event 2 Off Off, On
Event 3 Set Value Pro-1 Seg-1 Ramp Event 3 Off Off, On
Event 4 Set Value Pro-1 Seg-1 Ramp Event 4 Off Off, On
Soak Temp Seg 1 Pro-1 Seg 1 Soak Temp 68°F SPLowerLim to
SPUpperLim *
Soak Time Seg 1 Pro-1 Seg 1 Soak Time 00:00 00m00s to
99h59s
Event 1 Set Value Pro-1 Seg-1 Soak Event 1 Off Off, On
Event 2 Set Value Pro-1 Seg-1 Soak Event 2 Off Off, On
Event 3 Set Value Pro-1 Seg-1 Soak Event 3 Off Off, On
Event 4 Set Value Pro-1 Seg-1 Soak Event 4 Off Off, On
(repeat for segments 2-8)
High Limit Setpoint Pro-1 Hi-Lim SP Max
HiLimSP MinHiLimSP to
MaxHiLimSP *,
Band **
Loop From Pro-1 Loop From XX No No, Seg-1 to
Seg-8
Loop To Pro-1 Loop To XX No No, Seg-1 to
Seg-8
Loop Count Pro-1 Loop Number 0 0 to 99
Profile Link Pro-1 Link To XX Stop Standby***,
Stop, Hold,
Pro-1 to Pro-8
Guaranteed Soak Pro-1 Guar Band Off Off, 1 to 778°C
(1400°F)
(repeat for profiles 2-8)
* See Enable Page
** Band value is set on Control Page
*** If Standby
1. Cycle Complete LED indication goes ON.
2. Controller beeps if End Of Cycle beep is enabled.
3. Heater/control output keeps controlling oven temperature at last Soak setpoint.
4. All events programmed (if relay cards installed and programmed as an event) for
the last Soak Segment stays active.