Despatch LCC/LCD2-14-3 Non Pass Through Series - Manual (Page 31)

22
Pre-Startup Checklist
Know the system. Read this manual carefully.
Make use of its instructions and explanations.
The know how of safe, continuous, satisfactory,
trouble-free operation depends primarily on the
degree of your understanding of the system and
of your willingness to keep all parts in proper
operating condition.
Check line voltage. This must correspond to nameplate requirements of motors
and controls. A wrong voltage can result in serious damage. Refer to the
section on power connections in the INTRODUCTION of this manual.
Check fresh air & exhaust dampers. Do not be careless about restrictions in and
around the fresh air and exhaust openings and stacks. Under no condition,
permit them to become so filled with dirt that they reduce airflow.
If your oven is equipped with the “Class A” option (Models LCC/LCD2-14A*-3);
the purge timer is preset with the time listed on the nameplate at the factory.
WARNING: Do not use
any flammable solvent or
other flammable material
in this oven. Do not
process closed containers
of any substance or liquid
in this oven because they
may explode under heat.
CLASS A OVENS ONLY!
WARNING:
“Class A” ovens are designed for a specific amount of
solvent. Exceeding this amount could result in an explosion. Do not
process closed containers of any substance or liquid in this oven
because they may explode under heat. In case of fire, leave door(s) as
they are. Shut off electricity. Shut off fuel. Call the fire department.
Stay away.