Despatch LCC/LCD2-14-3 Non Pass Through Series - Manual (Page 32)

23
Operating Procedure
Starting the Oven
1.
Turn the yellow/red DISCONNECT SWITCH to ON.
2.
Press the POWER pushbutton ON switch.
The door remains unlocked. NOTE: during the process cycle the door is
locked. To unlock the door press the STOP push-button or remove power
from the oven by using the disconnect switch
(optional “Class A” equipped units) Once the power switch is turned on,
the recirculation fan and exhaust fan are turned on, the airflow switch will
actuate and the purge timer will begin timing. NOTE: The heater will not
turn on and the oven will not begin heating until the purge period is
complete.
(optional beacon light-equipped units) The amber (center) beacon light will
illuminate, indicating that the oven is ready to receive work to be
processed.
3.
The heater is wired in series with the door switch. The door must be completely
closed to activate the heater.
Sequence of Operation (with Optional Beacon Light)
This section describes operation of the oven with the optional beacon light feature.
1.
After the system is powered up (see above procedure), the Protocol Plus
controller is initialized.
2.
At this point the oven is idle, empty, door closed, and waiting for the next lot to be
processed. The Protocol Plus is not running a profile. The amber beacon light is
on steady for steps 2 through 5, until profile is started. Refer to the Protocol Plus
instructions in this manual.
3. Open the oven door.
4.
Place the product on the shelf in the oven. Close the oven door.