Replacing the print head – Dascom MIP480 User Guide User Manual

Page 74

Maintenance

5-6

Replacing the Print Head

If a specific dot is not printed for all characters, replace the print head.

To remove the print head:

1 Turn off the printer.

2 Open the cover and remove the ribbon cartridge.

3 Remove the two screws A from the print head.

4 Lift the print head and disconnect the flexible cables.

Removing the Print Head

To install the print head:

1 Connect the flexible cables to each connector. Make sure to push them fully into the

connectors; do not kink the cables.

2 Ease the new print head down into the mounting. Fasten the two screws A.

3 Install the ribbon cartridge.

WARNING:The print head may be hot if you have been printing recently.

WARNING:Be careful because the printhead cables can easily be damaged.

NOTE: A technician should preferably handle this procedure.

WARNING:Be careful because the printhead cables can easily be damaged.