Dascom MIP480 User Guide - Manual (Page 69)

5-1
5
Maintenance
Your printer requires very little care. Occasional cleaning and replacement of the ribbon
cartridge are all that is required.
Lubrication of the printer is not usually necessary. If the print head carriage does not
move smoothly back and forth, clean the printer in the manner described in this chapter.
If the problem continues, contact your dealer to determine whether lubrication may be
necessary.
Cleaning
The front and back covers and the acoustic cover of the printer help protect it against
dust, dirt, and other contaminants. However, paper produces small particles that accu-
mulate inside the printer. This section explains how to clean and vacuum the printer and
how to clean the paper bail rollers.
It is easier to clean the printer when the cover is open.
Cleaning and Vacuuming the Printer
If the print head carriage does not move smoothly back and forth or paper particles have
accumulated in the printer, clean the printer.
To clean and vacuum the printer:
1 Remove any paper from the printer. Make sure that the power is off, and then discon-
nect the printer power cord.
2 Using a soft vacuum brush, vacuum the exterior of the printer. Also vacuum the cut
sheet edge
3 Use a soft, damp cloth to wipe the exterior of the printer, including the cover. A mild
detergent may be used.
WARNING:To avoid any possibility of injury, before cleaning the printer, turn off the
power to both the printer and the computer, and unplug the printer.
WARNING:Do not use solvents, kerosene, or abrasive cleaning materials that may
damage the printer.