Dascom MIP480 User Guide - Manual (Page 52)

Using Special Mode
4-18
Safe Panel
• If the value of safe panel is “YES”, READY, PARK and LOAD require the ALT key to
be used as a two key operation for these functions in Normal Operation Mode of
printer.
• If the value of safe panel is “NO”, READY, PARK and LOAD key are operated as Nor-
mal Operation Mode, ALT key is not required.
Recalling Factory Settings
Factory settings are those settings pre-selected at the factory. To recall (reset) the factory
settings, select the RCALL-FACT function and press the ALT-NEXT key or the ALT-PRE-
VIOUS key.
Options under the MACRO, INSTALL, and Adjustment functions are all initialized to the
factory settings.
Word Length setting
Select the same word length setting that is
used by your computer or modem.
1 BIT 1 Stop bit per data byte
2 BIT 2 Stop bits per data byte
The ready/busy control method.
DTR Hardware control via the DTR lead.
XON/XOFF Data control using DC1 and DC3 control
characters.
6820 PROT For 6820 emulation
Disconnect on a fault condition
NO Do not disconnect.
DROP DTR DTR will change to inactive state.
PULSE DTR DTR will pulse to inactive and then back to
the normal active state.
Sets time after which Sleep Mode is automat-
ically activated
0 Disables Sleep Mode
1-96 Hours after which Sleep Mode is automati-
cally activated
INSTALL Options Values Description