Dascom MIP480 User Guide User Manual
Page 62
Using Special Mode
4-28
Setting of The First Dot Position on The Left Side Function
Print positions often change gradually when you use the printer over long periods of time.
This ADJUST function allows you to adjust these positions by fine-tuning the Left Margin
origin.
1 To enter Adjustment Function:
a) Make sure that the tractors are loaded with continuous feed paper and that the pa-
per select lever is set backward.
b) Turn the printer off.
c) Turn the printer back on while simultaneously pressing the READY/CLEAR + ALT
+ LOAD/FF keys.
2 To set Adjustment value:
a) The format of adjustment of setting of the first dot Position on the left side is printed
as below, 15 patterns of adjustment Position are printed.
b) After the format of setting of the first dot Position on the left side is printed, the pa-
per is automatically advanced for viewing after the printing is complete. The message
of ”1st Print Position Pos = xx” is printed.
c) Use the NEXT and PREVIOUS keys to choose the new first dot position on the left
side. The adjustment range is "01-15", and the center value is "08".
It is possible to set different values for Tractor and Manual
NOTE: Do not press any keys alone or in combination, except for pressing the
“READY/CLEAR” + “ALT” + “LOAD/FF” keys simultaneously, when turning the
printer on, to avoid initiating unexpected tests not permitted for the user.
01H
02H
03H
04H
05H
06H
07H
08H
09H
10H
11H
12H
13H
14H
15H
1 Print Position = xx
st
10/60
inch