Dascom MIP480 User Guide User Manual

Page 110

Command Sets

C-16

Function

Command

Vertical Control
Line feed

Form feed

Advance paper n/180 inch (1

≤ n ≤ 255)

ESC J (n)

Set line spacing to 1/8 inch

ESC 0

Set line spacing to n/180 inch (0

≤ n ≤ 255)

ESC 3 (n)

Set line spacing to n/60 inch (0

≤ n ≤ 127)

ESC A (n)

Set line spacing to 1/6 inch

ESC 2

Set line spacing to n/360 inch (0

≤ n ≤ 255)

ESC + (n)

Tabulation
Horizontal tab execution

Set horizontal tabs

ESC D (n1) ... (nk) NUL

The values of n1to nk in this command are the ASCII values of
the print columns (at the current character width) at which tabs
are to be set.
(1

≤ n ≤ 255) (1 ≤ k ≤ 32)

Move print position n/120 inch (for draft)(*1)

ESC $ (n1) (n2)

or n/180 inch (for letter)(*1) right from left margin
(n = n1 + n2 X 256)

Move print position n/120(*1) inch (for draft)

ESC \ (n1) (n2)

or n/180(*1) inch (for letter) left or right from the current
position
(n = n1 + n2 X 256)

Vertical tab execution

Set vertical tabs

ESC B (n1) ... (nk) NUL

The values of n1to nk in this command are the
ASCII values of the lines (at the current line
spacing) at which tabs are to be set.
(1

≤ n ≤ 255) (1 ≤ k ≤ 16)

Move to dot line (d1 + d2 X 256)/360(*2) inch

ESC ( V (n1) (n2) (d1) (d2)

n1 = 2, n2 = 0
(0

≤ d1 ≤ 255) (0 ≤ d2 ≤ 127)

Vertical relative move by (d1 + d2 X 256)/360(*2) inch ESC ( v (n1) (n2) (d1) (d2)

n1 = 2, n2 = 0
(0

≤ d1 ≤ 255) (0 ≤ d2 ≤ 127)

–32768

≤ d1 + d2 X 256 ≤ 32768

*1 The value depends on the pitch set by the ESC (U command.
*2 The value depends on the pitch set by the ESC (U command. The default is 1/360 inch.