Dascom MIP480 User Guide - Manual (Page 21)

Paper Handling
2-13
5 Raise the tractor doors and fit the first two paper feed holes onto the right tractor pins.
6 Holding paper against the Easy-Load Platform, fit the paper into the tractor. Close the
tractor Door. Repeat the procedure for the left tractor and adjust the left forms tractor
to accommodate the width of the form.
7 Move the left tractor to make the paper flat. Do not stretch the paper too taut. Push
the left locking lever down to secure the tractor in place.
8 Press the FF/LOAD key to advance the paper to the top-of-form position from which
printing can start. The printer is automatically placed in the Ready State.
9 Press the READY key to place the printer on line. Print a sample page and check the
page margins. Make the following adjustments, as necessary:
• Horizontal alignment. Move the forms tractors as required with paper parked.
• Top-of-form setting. Use the printer Set-Up mode (see Chapter 4, “using the Set-
Up Mode”).
• Margin settings. Use your software or the printer Set-Up mode (see Chapter 4,
“using Set-Up Mode”).