Dascom MIP480 User Guide - Manual (Page 13)

Paper Handling
2-5
Operation Required Conditions
*1
Required Action
Ready Printing
*2
Fault
Load continuous forms
paper — Not printing On Press FF/LOAD.
Load single sheet paper — Not printing On Paper is automatically
detected and advanced (auto-
loading) when it is first
inserted. In this mode, if the
FF key is pushed, the inserted
sheet will be ejected from the
printer and the Fault LED will
light, indicating paper out
condition.
Feed paper a page — Not printing Off Press FF/LOAD.
Advance perforation to
tearbar — Not printing Off Press READY.
Eject single-sheet
paper — Not printing Off Press FF/LOAD. The Fault
LED will light, indicating a
paper out condition.
Unload continuous-
forms paper — Not printing Off Press Park.
Pause printing On Printing Off Press READY
Resume printing Blinking Not printing Off Press READY
Resume printing after a
fault Off Not printing On Clear error and press READY.
Resume printing after
paper out Off Not printing On Load paper.
Place printer in Ready
state Off Not printing Off Press READY
Place printer in pause
state On — Off Press READY
Enter Normal mode N/A N/A N/A Turn power on without press-
ing any keys
Enter Sleep mode N/A Not printing N/A Press POWER/SLEEP for five
seconds
Leave Sleep mode N/A Not printing N/A Press POWER/SLEEP for
one second
Printing test N/A N/A N/A Turn power on while pressing
FF/LOAD key.
Use the adjustment
temporarily Off — Off Press ALT-NEXT.
Use the adjustment
permanently Off — Off Press SETUP/EXIT.
Clear the adjustment Off — Off Press ALT-PREVIOUS.