Atop Technology SE5002D User manual - Manual (Page 64)

Atop Serial Device Server
SE5002D
User Manual V. 1.1
4.2 Virtual COM
4.2.1 Enable Virtual COM in Serial Device Servers
Enable Virtual COM in our serial device servers by logging into our WebUI. It is located under
COM configuration. Following figures show how to enable Virtual COM in SE5002D. For
detailed Link Mode configuration with Virtual COM, please refer to the previous sections
starting from Sec. 3.5 on Link Mode configurations.
Fig. 4. 2
It is also possible to enable Virtual COM in serial device servers using Telnet. Please refer to
the Sec. 3.2.8 on Telnet.