1 configuration by serial manager, 2 configuration by telnet utility, 1 login to the system – Atop Technology SE5002D User manual User Manual
Page 21: Configuration by serial manager, Configuration by telnet utility, Login to the system

Atop Serial Device Server
SE5002D
User Manual V. 1.1
3.1 Configuration by Serial Manager
SE5002D could be configured by Serial Manager, for more information, refer to Serial
Manager’s manual.
3.2 Configuration by Telnet Utility
You can use a Telnet utility to change configuration settings of SE5002D by following the
steps:
3.2.1 Login to the System
Open MS-DOS command prompt window or any other telnet application.
Telnet to SE5002D using the command
“telnet IP_address”. (For example: “telnet
10.0.50.100” in MS-DOS command prompt window). After telnet into SE5002D, the
system will prompt for a password is blank,
Fig. 3. 1
Note: Press the default button of SE5002D to reset the password to the default value.