Atop Technology SE5002D User manual - Manual (Page 55)

Atop Serial Device Server
SE5002D
User Manual V. 1.1
3.6 TCP Client Application
3.6.1 Enable Virtual COM
It is also possible to run Virtual COM in TCP Client mode, Fig. 3. 32 . It is usually easier to use
Virtual COM in the Client mode if SE5002D uses dynamic IP (DHCP) because setting a static
IP address in Virtual COM’s Control Panel is not possible.
Fig. 3. 32
 Follow Sec. 3.2.6 to configure SE5002D in TCP Client mode properly.
 Check Enable Virtual COM for Serial/IP to enable Virtual COM application in SE5002D.
 Scroll to the bottom of the page and click on “Save Configuration” button to save the
changes.
 Configure Virtual COM in the OS. For Windows, refer to Using Virtual COM . Remember
this SE5002D ’s IP address and the Local Listening Port here in order to enter this
information in Serial/IP Virtual COM ’s Control Panel later.