Atop Technology GW51C-MAXI-WDT User manual - Manual (Page 35)

User manual Version 1.4
GW51C-MAXI Serial Server
Copyright © 2004 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
34 / 68
At right is a sample Virtual COM Control Panel window. At the left is the list of the COM ports that one
have selected (in the Select Ports window) for use by the Virtual COM Redirector. If you wish to change
which ports appear in this list, use the Select Ports button.
Each COM port has its own settings. Once one click on COM port, the Control Panel display should
change the settings for that COM port.
Note: When one changes settings for a COM port, the changes are effective immediately. There is no
separate confirmation dialog to confirm or cancel one should change.
Configuring Virtual COM Ports
One configure each Serial/IP COM port as follows:
1.
Select a COM port in the list.
2. For IP Address of Server, enter a numeric IP address for the serial server.
3. For Port Number, enter the TCP port number that the serial server uses to provide its serial
ports to the network.
4. For Server Credentials, the default is No Login Required. If one serial server does require a
login by the Virtual COM Redirector, the Virtual COM Redirector needs to provide a username