AirLive Traveler3G User Manual

Page 15

3. Configuring the Traveler 3G

AirLive Traveler 3G User’s Manual

To prepare your PC for management with the Traveler 3G, please do the following:

1. Connect your 3G/3.5G USB modem to the USB port located on the top side of the

router.

2. Connect your computer to the Ethernet port on the right side of the router for configuring

the router.

It is recommended to configure the router through the Ethernet

port for the first time setup.

3. Switch on the button of “ON/OFF” to turn on the router

4. Please check all LEDs on the front side. “PWR/CHR” LED should be steadily on in

green color, and “ETHERNET” LED should be on.

5. If PWD LED is not on, or any LED you expected is not on, please recheck the cabling, or

jump to “Chapter 9 Troubleshooting” for possible reasons and solution.

You are ready now to configure the Traveler 3G using your PC.