AirLive MW-2000S - Manual (Page 123)

Chapter 7. Web Interface Configuration
AirLive MW-2000S User’s Manual 118
Source/Destination IP: Enter the source and destination IP addresses.
Source/Destination Subnet Mask: Enter the source and destination subnet masks.
Source/Destination Start/End Port: Enter the range of source and destination ports.
Source MAC Address: The MAC address of the source IP address. This is for specific MAC address
filter.
Action: There are two options, Block and Pass. Block is to prevent packets from passing and Pass is to
permit packets passing.
¾ Specific Route Profile
The default gateway of WAN1, WAN2, or a desired IP address can be defined in a policy. When Specific
Default Route is enabled, all clients applied this policy will access the Internet through this default
gateway.
IP Address: The destination IP address of the host or the network.
Subnet Netmask: Select a destination subnet netmask of the host or the network.
IP Address: The IP address of the next router to the destination.
Default Gateway: Check this option to apply the default value.