2N VoiceBlue Lite - Manual v2.6 - Manual (Page 91)

2N - VoiceBlue Lite
• First RTP port – the first RTP port number.
The RTP port number is recommended to be even.
• Last RTP port – the last RTP port number. The RTP port
number is recommended to be even. The recommended
range of RTP port is 10 at least.
• SIP registration – set the parameters of VoiceBlue Lite
registration at the SIP Proxy;
• Registration expires – the timeout after which the
VoiceBlue Lite registration data get expired at the SIP
Proxy.
• Reattempt registration – the timeout after which the
request is resent.
• Registration domain – If the “SIP registrar” field is
empty, VoiceBlue Lite registers to the domain set in this
field.
• Name – user name
• User – user name for authentication
• Password – Password required for authentication with
SIP proxy
• Codecs priority – define which speech coding codec types
should be preferred. Codecs as recommended by ITU-T
G.729, G.711 and G.723.1 might be used (for more details
refer to Subs. 5.1).
• Codecs settings – sets how many speech blocks shall be coded
with the given algorithm at the same time. Coding of a high
number of blocks results in a lower resultant transmission rate
and a higher voice transmission delay.
• SIP protocol setting – used for setting SIP report sending
during establishing connection. In this section is possible to set
replacement of CLIP from GSM by the Name set in the SIP
registration section.
• IP addresses – used for setting IP addresses of interworking
network devices and default port numbers through which
VoiceBlue Lite will communicate with them.
81