2N VoiceBlue Lite - Manual v2.6 - Manual (Page 64)

Recording DISA using terminal and protocol Xmodem
Recording DISA announcement
Run the terminal programme supporting the protocol Xmodem and
use it to connect up with VoiceBlue.
• Using the AT order at!m#=write, where instead of # fill in the
number of the announcement which is meant to be loaded into
VoiceBlue. The value “0” is designated for the announcement
DISA, the numbers of the other announcements are given
in chapter 6.4.
• After the insertion of an order you will be called upon to select
an audio file which is to be loaded into VoiceBlue.
• Successful loading is announced by a message
Loading DISA announcement
• Run the terminal programme supporting the protocol Xmodem
and use it to connect up with VoiceBlue
• Using the AT order at!m#=read, where instead of # fill in the
number of the announcement which is meant to be loaded into
VoiceBlue. The value “0” is designated for the announcement
DISA, the numbers of the other announcements are given
in chapter 6.4.
• After the insertion of an order you will be called upon to select
the name of the audio file under which the announcement from
VoiceBlue is to be filed.
Deleting DISA announcements
You can gain information about a loaded DISA announcement
using the AT order at!m0=view. To delete a DISA announcement,
enter the order at!m0=erese in the terminal window.
54