2N VoiceBlue Lite - Manual v2.6 - Manual (Page 121)

2N - VoiceBlue Lite
•
List of Terminal AT Commands
•
Records on Operation (LOG)
•
Records on Calls (example)
•
Statistics – Description
11.1. Serial Communication Setting
Use a full crossed (laplink) RS232 cable for serial communication.
Also set the following communication parameters:
Communication rate: 57,600 bps
Number of bits: 8
Stop bits: 1
Parity: none
Flow control: Hardware
File transmission protocol: XMODEM
11.2. USB Communication Setting
To establish USB communication, install the enclosed driver,
which installs a virtual COM port in the Windows system. You
can, e.g., use the HyperTerminal communication software for
communication. Set the following parameters:
Transmission rate: 921,600 bps
Data bits: 8
Parity: none
Stop bits: 1
Flow control: none
11.3. TCP/IP Communication Setting
To communicate with the 2N - VoiceBlue Lite gateway through
the LAN, set the LAN IP address first. To do this you need a direct
serial or USB PC connection. You can use such TELNET
supporting programs for TCP/IP communication as
HyperTerminal, Putty, etc.
111