2N VoiceBlue Lite - Manual v2.6 - Manual (Page 127)

2N - VoiceBlue Lite
; ri,ro redirected inc,out calls
%TL=m,c,m,c init minutes,calls in lan (0..65535)
%TG#=m,c,ri,ro init minutes,calls,rin,rout in group # (0..65535)
%TGALL=m,c,ri,ro init minutes,calls,rin,rout in all groups (0..65535)
%TI#=m,c init minutes,calls in inc.group # (0..65535)
%TIALL=m,c init minutes,calls in all inc.groups (0..65535)
%TM#=m,c,s,m,c,s init minutes,calls,sms in mod # (0..65535)
%TMALL=m,c,s,m,c,s init minutes,calls,sms in all modules (0..65535)
Service AT commands:
!V0FB=key set system key
!RE report errors only
!RR start report layer2..4 on COM1 (from COM2)
!RX stop report layer2..4 on COM1 (from COM2)
!R# report messages
1=layer1..4
2=layer2..4
3=layer3..4
4=layer4
!L# report
lan
2=ip/arp..telnet
3=tcp/udp..telnet
4=telnet
!P view
process info
!Q view system info
!SG##=ddd,ccc setup new call from AUX to gsm (0..31,32=by prefix)
!SP##=ddd,ccc setup new call from AUX to SIP/IP (%E11) ## is ignored
!SE##=ddd,ccc setup new call from AUX to SIP/IP (%E11) ## is ignored
!WG## wait on call from gsm 0..31,32=all to aux
!WE## wait on call from pri2 1..15,17..31,32=all to aux
!D disconnect call from/to aux
!G=A9 Starts ext. callback control
!SB##=VoIPdial,gsmdial,limit Setup new callback VoIPdial=number dialed to VoIP,
gsmdila=number dialed to GSM, limit=max.length of call
Special GSM commands:
at&g##=at+cnum view own number
at&g##=at+cpin="####" set pin (before pin checking off !!!)
117