Service at commands, Special gsm commands, Network params – 2N VoiceBlue Lite - Manual v2.6 User Manual
Page 126: Routing params, Totals

%P07=uuu/HH:MM,
pseudo tarif extension
%P09=mode,sec
pseudo mode (0=off,1=cdr,2=cdr+lan), count of secbetween
AOC (1..250)
Network params:
%N#0=opx/npx,
list of old/new main-prefixes (max 47 chars)
%N#1=pref/dig, list
of
prefixes/digits-to-end (max 63 chars)
%N#2=pref/dig,
pref. list extension (max 63 chars)
%N#3=pref/dig,
pref. list extension (max 63 chars)
%N#4=pref/dig,
pref. list extension (max 63 chars)
%N#5=pref/dig,
pref. list extension (max 63 chars)
%N#6=pref/dig,
pref. list extension (max 63 chars)
%N#7=pref/dig,
pref. list extension (max 63 chars)
%N#9=netid,max
network id (7 chars), default max digits (0..20)
Routing params:
%A##=clip,dial
Autodial (autocallback restricted) clip=clip from GSM, dial=dial
to VoIP
%A##=clip,dial,limit Autodial
or
autocallback clip=clip from GSM, dial=dial
to VoIP,limit=max length of call
%A##=clip,,limit
Autocallback (autodial restricted) clip=clip from GSM,
,limit=max length of call
%R##=net,hh:mm/hh:mm/w+-,groups,lim set lcr-routing item (ix 0..63)
net (1..8), groups (max 7 chars=1..9)
call limit (0=off, 1..99min)
DISA record commands
!m=erase
erase of DISA message
!m=record
record of DISA message from modul g0
routine for DISA record
establish call to GSM: at!sg0={GSM phone number}
after connect type: at!m=record
recording of the message (65 sec or press
hang ap on VB site: at!d
Totals
; first m,c,s
inc. minutes,calls,smses
; second m,c,s
out. minutes,calls,smses
116