2N VoiceBlue Lite - Manual v2.6 - Manual (Page 122)

IP address: gateway address set by you
Port: 23
11.4. Terminal Communication
The terminal is also part of the GSM configuration software. To
start the terminal use the CTRL – Terminal button menu. Be sure
to configure the GSM program properly for communication (refer
to Subs. ).
11.5. GSM Gateway Behaviour
The gateway behaves as an ANSI terminal with an echo. The
commands are entered in the text format and the X-modem
protocol is used for file transfer. An access password is required,
the gateway returns the USER and PASSWORD: prompts; if the
password has been entered or is not required, the '>' prompt is
used. The gateway uses an extended set of AT commands for
configuration. For the list of AT commands see below.
11.6. List of Terminal AT Commands
All commands start with AT by default. (Note: Some of the below
mentioned AT commands may not be available in the current
firmware versions.)
Basic AT commands
A/ repeat last command (without AT)
I3 copyright & firmware
I4 serial number
&FRES factory defaults & reset
&V view active parameters (system)
&VE view active parameters (ethernet)
&V0 view active parameters (common)
&V1 view active parameters (groups 1..4)
&V9 view active parameters (inc. groups)
&P view pseudo params
&N# view network params (net 1..8)
&NALL view all network params
112