Eppendorf FemtoJet 4x v.1 User Manual
Femtojet
Table of contents
Document Outline
- FemtoJet® 4i
- Table of contents
- 1 Operating instructions
- 2 Product description
- 3 Safety
- 4 Installation
- 5 Software
- 6 Operation
- 6.1 Switching on or off the Microinjector
- 6.2 Switching on or off the standby mode
- 6.3 Determining the injection parameters
- 6.3.1 Filling the capillaries with fluorescence dye
- 6.3.2 Carrying out a test injection
- 6.3.3 Possible sources of error - cell inflates or bursts
- 6.3.4 Possible sources of error - capillary is clogged
- 6.3.5 Possible sources of error - liquid is not being injected
- 6.3.6 Possible sources of error - capillary does not reach the cell
- 6.3.7 Result – the injection parameters have been determined
- 6.4 Setting the compensation pressure pc
- 6.5 Setting the injection pressure pi
- 6.6 Setting the injection time ti
- 6.7 Setting the injection mode
- 6.8 Injecting liquid
- 6.9 Replacing the capillary
- 6.10 Rinsing the capillary
- 6.11 Setting the injection counter to zero
- 6.12 Calling up saved injection parameters
- 6.13 Saving or changing the injection parameters
- 6.14 Adjusting the device settings
- 6.14.1 Change capillary function – Changing the capillary
- 6.14.2 Pressure unit function – Selecting the pressure unit
- 6.14.3 Beeper function – Switching on/off the signal tone
- 6.14.4 Contrast function – Setting the display contrast
- 6.14.5 Illumination function – Switching on/off the display illumination
- 6.14.6 Continuous flow function – Setting the constant operating pressure
- 6.14.7 Drain pressure supply function – Draining the pressure reservoir
- 6.15 Inserting the capillary into the capillary holder
- 6.16 Inserting Femtotips into the capillary holder
- 7 Troubleshooting
- 8 Maintenance
- 9 Technical data
- 10 Transport, storage and disposal
- 11 Ordering information
- Declaration of Conformity