Eppendorf FemtoJet 4x v.1 - Manual (Page 21)

Installation
FemtoJet ® 4i
English (EN)
21
4.4.1 Connecting a micromanipulator
Prerequisites
• Y-cable FJ4 is available.
• The Microinjector is switched off.
• The micromanipulator is switched off.
1. Connect the Y-cable to the MANIPULATOR port.
2. Connect the micromanipulator to the Y-cable.
3. Switch on the Microinjector.
The initialization phase starts.
After completion of the initialization phase, the main screen appears.
4.4.2 Connecting the PC
Prerequisites
• Y-cable FJ4 is available.
• Devices are switched off.
1. Connect the Y-cable to the MANIPULATOR port.
2. Connect the computer to the Y-cable.
3. Switch on the Microinjector.
The initialization phase starts.
After completion of the initialization phase, the main screen appears.
The operation is described in the manual for the micromanipulator.
Control with a PC is described in the Cell Technology · PC Control manual.