Eppendorf FemtoJet 4x v.1 - Manual (Page 39)

Troubleshooting
FemtoJet ® 4i
English (EN)
39
7.2.3 Error 19 – 38
Symptom/message Cause Remedy
Error #19 • System error

Switch the device off and
back on again.

If the error persists, please
contact the authorized
service.
Error #20 • System error
Error #21 • System error
Error #22 • System error
Error #23 • System error
Error #24 • System error
Error #25 • System error
Error #26 • System error
Error #27 • System error
Error #28 • System error
Error #29 • System error
Error #30 • System error
Error #31 • System error
Error #32 • System error
Error #33 • System error
Error #34 • System error
Error #35 • System error
Error #36 • System error
Error #38 • System error
Warning #37 • Micromanipulator is not
connected correctly.

Press the menu enter key.

Check the micromanipulator.

Check the connecting cable.

If the error persists, please
contact the authorized
service.
• Micromanipulator takes too
much time for the action to
be performed until sending
an answer.