Eppendorf PatchMan NP 2 - Manual (Page 35)

80
Before cleaning the PatchMan NP 2, disconnect the plug.
Ensure that no fluids enter into the inside of the micromanipulator in order to avoid short-circuits
in the electrical installation as well as corrosion.
Wipe painted parts and aluminum surfaces using a cloth and mild detergent and then with a dry
cloth.
Warning : Do not use any corrosive, solvent or abrasive detergents or polishes.
Clean the PatchMan NP 2 before disinfecting.
Wipe every part of the PatchMan NP 2, including accessories and connector cables, with an
alcohol-based disinfectant (Isopropanol, Alcohol).
Spray disinfection is not advisable, as disinfectants can enter into the micromanipulator.
The disinfection method used must comply with current disinfection regulations and guidelines.
If the device is to be inspected or repaired by the service partners of the Eppendorf AG,
it must be free of hazardous substances and clean!
A decontamination certificate must accompany the PatchMan NP2.
A printed form ("Decontamination certificate for return of goods" and general instructions for
decontamination are available at our www.eppendorf.com homepage.
The serial number of the device must be entered in the decontamination certificate.
The dealer is responsible for warranty and service.
6.1 Cleaning
6.2 Disinfection
6.3 Decontamination prior to shipping
6.4 Service
Care and maintenance
6 Cleaning and service
6
06_Wartung_e.fm Seite 80 Donnerstag, 1. Februar 2007 10:37 10