Eppendorf PatchMan NP 2 - Manual (Page 23)

68
4.3.6 Position change in X direction
Depending on the desired angle and/or the length of the tool, it may be necessary to remove the
motor module further away from the working point.
This change of position in X direction can be effected in two ways:
1. Change by way of mounting point
at hinged bracket:
The hinged bracket can be mounted such
that the motor module is positioned further
out or further in relative to the microscope.
Example:
The hinged bracket is mounted such that the
left side mounting is further out in this case.
2. Rotate X head on X module:
Dismantle X head and mount it at front hole
as shown in illustration.
4.3.7 Grounding of the motor module
The motor module can be grounded over the tapholes of the silver rod on the reverse side of the
motor module. A M 5 x 8 screw and a toothed disc, for example, can be used for this purpose.
0
40°
40°
20°
20°
Installation
4 Installation
4
04_Install_e.fm Seite 68 Dienstag, 16. August 2005 3:17 15