Eppendorf PatchMan NP 2 - Manual (Page 19)

64
4.3.1 Right and left side mounting
The module unit mounting is dependent on the
chosen side of the microscope.
The module unit can be mounted on the most
commonly used microscopes (usually inverted
microscopes). The unit is mounted on the
microscope tripod by way of a separately
ordered microscope-specific adapter.
Mounting of the adapter is described in the
relevant mounting instructions. If a different
type of mounting is required, special adapters
will be needed.
The hinged bracket is mounted on the adapter
by one of the two longer rollers as shown in
illustration (here right side mounting; for the
sake of clarity the mounted X module is not
shown).
The M5x16 screw is supplied as part of the
PatchMan NP 2 accessory set; the roller is
a component of the microscope-specific
adapter.
The rollers are adapter-specific.
The module unit (here on the right) is joined to
the adapter by way of the roller with two
M5x16 screws. The PatchMan NP 2 is
mounted at the front position.
The screws are component parts of the
microscope-specific adapter.
Note: The installation is carried out according
to the planned mounting (section 5.4.3).
4.3 Mounting the module on the microscope
4 Installation
Installation
4
04_Install_e.fm Seite 64 Dienstag, 16. August 2005 3:17 15