Eppendorf PatchMan NP 2 - Manual (Page 15)

60
Moving the mounting point of the straight-line guide upwards changes
the adjustable height.
Moving the straight-line guide downwards allows less steeply inclined
angles to be set for the tool.
4.2.3 Assembling the X module
Note: The orange fixing screw on the narrow front face of
the X module must be slackened prior to adjusting the
height and must then be re-tightened in order to ensure
reliable operation.
The straight-line guide is already bolted to the X module.
Turn the spindle as far as necessary to make the desired
mounting point accessible.
Set the straight-line guide with the
free hole (2) at the mount (1) of the
X/Y unit. The fitting pins must be
fitted into the holes provided. Fix
the straight-line guide to the Z/Y
module by the M4x10 cheese
head screw.
Note: Make sure you do not
mount the X module too low! If
you do, the motor module may
come to rest on the microscope
table as it moves down. This may
damage the drives!
2
1
Installation
4 Installation
4
04_Install_e.fm Seite 60 Dienstag, 16. August 2005 3:17 15