Aerovent IM-500 - Manual

©2013 Aerovent
Table of Contents
Unit Information .......................................................................... 1
Special Precautions ....................................................................... 2
Installation Codes ...................................................................2 - 3
Unit Location Restrictions ......................................................... 3
Sound and Vibration Information ............................................ 3
Installation Information ........................................................3 - 5
Electrical Installation ................................................................... 5
Gas Piping Installation ..........................................................5 - 7
Operating Instructions and Parts ......................................7 - 12
Start-Up Procedure ............................................................12 - 14
Sequence of Operation .....................................................14 - 15
Circuit Analyzer/Troubleshooting ..................................15 - 16
Maintenance Recommendations .....................................16 - 18
Terms & Conditions/Warranty .......................................19 - 21
Start-Up Report ..................................................................22 - 24
FOR YOUR SAFETY
If you smell gas:
1. Open windows.
2. Do not touch electrical switches.
3. Extinguish any open flame.
4. Immediately call you gas supplier
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause
property damage, injury or death. Read the
installation, operating and maintenance in-
structions thoroughly before installing or
servicing this equipment.
FOR YOUR SAFETY
The use and storage of gasoline or other flammable vapors and liquids in open containers in the
vicinity of this appliance is hazardous.
Gas-fired appliances are not designed for use in atmo-
spheres containing flammable vapors or duct, or atmo-
spheres containing chlorinated or halogenated chlori-
nated or halogenated hydrocarbons.
Recirculation of room air may be hazardous in the
presence of: a) flammable solids, liquids and gases; b)
explosive materials (ie., grain dust, coal dust, etc.); and
c) substances that may become toxic when exposed to
heat.
An electrical disconnect must be installed having ad-
equate ampacity (see marking on the heater for voltage
and ampacity), if the unit was not provided with one.
This disconnect shall be installed in accordance with
Article 430 of the National Electrical Code, ANSI/
NFPA 70.
This manual is the property of the owner. Please be
sure to leave it with them when the installation and
start-up of this equipment has been completed.
As Aerovent has a continuous product improvement
program, we reserve the right to change designs and
specifications without notice.
Direct Fired Air Make-Up Unit
Aerovent Regional Office
800 S. High St.
Covington, OH 45318
(937) 473-3788
Aerovent Headquarters
5959 Trenton Lane
Minneapolis, MN 55442
(763) 551-7500
General Installation, Operation and Maintenance Instructions For Aerovent Products
IM-500
August 2013
®