Snorkel AB46J - Manual (Page 16)

❑
Flashing Lights
The optional flashing lights alert people that the
AB46J is present. The lights flash at about one
flash per second any time the Battery switch,
Master Key Switch, and the Emergency Stop
switch (at the ground) are all ON. There is no
ON/OFF switch for the flashing lights.
❑
Platform Foot Switch
The platform foot switch prevents the platform
from moving if something accidentally pushes
one of the platform moving controls on the
platform control box. (Stepping on the foot switch
is an action that must be performed, at the same
time as another action, to make the platform
move.)
Serious Injury can result from sudden stops.
To avoid sudden stops, Do Not remove your
foot from the foot switch while the AB46J is in
motion.
❑
GFCI (Ground Fault Circuit Interrupt)
The (GFCI) ground fault circuit interrupt is located
near the platform control box. To use the outlets,
connect the power input connector, on the top
rear of the chassis, to a source of 125 volt AC,
15 A electrical power.
The GFCI protects against electricity flowing to
ground. When electricity flows to ground the
GFCI shuts off power to the electrical outlets.
To reset the outlets:
1. Unplug the equipment being used.
2. Press the RESET button on the GFCI.
This should restore power to the outlets. If it does
not, unplug the source of power and refer the
problem to a trained service technician.
❑
Platform Gravity Gate
The platform gravity gate is the place in the
platform guardrail system where you should enter
and leave the platform. Raise the gate and step
under it onto the platform. Once you have entered
the platform and attached your fall restraint
lanyard to an anchor point, check to see that the
gravity gate has fallen back into place.
page 2 - 2 AB46J – 0163187
2. Safety Devices
DANGER