Abels – Snorkel Bi-Energy-sn4275+ User Manual
Page 20
Page 18
Operator Manual
067449-023 LX31/LX41 Electric and BiEnergy
Labels
L
ABELS
These labels shall be present and in good condition before operating the work platform. Be sure to read,
understand and follow these labels when operating the work platform.
NEVER charge batteries near sparks of open flame. Charging batteries emit explosive hydrogen gas.
Dismantling the swing gate or the liftable bar or other railing components IS PROHIBITED! Always make
certain that the swing gate or the liftable bar is closed and securely locked! IT IS PROHIBITED to keep
the swing gate or the liftable bar in an open position (e.g. held open with tie-straps) when the platform
is raised!
To extend the height or the range by placing of ladders, scaffolds or similar devices on the platform
IS PROHIBITED!
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks,loose wire
connections, and damaged cables or hoses before using.
VERIFY that all labels are in place and legible before using.
NEVER use a machine that is damaged, not functioning properly, or has damaged or missing labels.
IF ALARM SOUNDS while platform is elevated, STOP, carefully lower platform. Move machine to a firm,
level surface.
To bypass any safety equipment IS PROHIBITED and presents a danger for the persons on the aerial work
platform and in its working range.
Exceeding the specified permissible maximum load on the platform IS PROHIBITED!
The use and operation of the aerial work platform as a lifting tool or a crane (lifting of loads from
below upwards or from up high on down) IS PROHIBITED!
NEVER exceed 400 N of side force.
DISTRIBUTE all platform loads evenly on the platform.
NEVER operate the machine without first surveying the work area for surface hazards such as
holes, drop-offs, bumps, curbs, or debris; and avoiding them.
OPERATE machine only on surfaces capable of supporting wheel loads.
NEVER operate the machine when wind speeds exceed 28mph (12.5m/sec.=Beaufort scale 6).
IN CASE OF EMERGENCY push emergency stop button to deactivate all powered functions.
Climbing up the railing of the platform, standing on or stepping from the platform onto buildings, steel
or prefab concrete structures, etc., IS PROHIBITED!
USE OF THE AERIAL WORK PLATFORM: This aerial work platform is intended to lift persons and
their tools as well as the material used for the job. IT IS designed for repair and assembly jobs and
assignments at overhead workplaces (ceilings, cranes, roof structures, buildings etc.). All other uses
of the aerial work platform ARE PROHIBITED!
THIS AERIAL WORK PLATFORM IS NOT INSULATED! For this reason it is imperative to keep a safe
distance from live parts of electrical equipment!
ALL occupants must wear an approved fall restraint properly attached to a designated platform
anchorage point. Attach only one fall restraint to each anchorage point.
Model______________
Serial number:___________
Machine weight _______kg
Mfg. date:_________
Maximum wheel load:________
Maximum allowable incline of machine when elevated:_____deg.
Occupants and equipment must not exceed the rated maximum
load:_____kg Maximum platform occupants: _____
Maximum allowable sIde force on platform:_____N
Maximum platform height:______m
Maximum platform reach:______m
Maximum allowable wind speed: ______m/s=Beaufort scale_____
Maximum hydraulic system pressure:_____bar
Maximum system voltage: _______Vd c
This machine is manufactured to comply with
Machinery directive 89-392/CEE
CAUTION: CONSULT OPERATOR'S MANUAL BEFORE USE.
061205-003
If horn sounds continuously
lower platform and relevel.
TIPPING HAZARD
TIPPING HAZARD
Check tire pressure daily.
Pressure must be
maintained at 50 P.S.I.
WARNING
Do not turn chassis control switch
to the brake release position and
press the brake release button to
disengage the brakes without
restraining the machine from rolling.
WARNING
TIP-OVER HAZARD
BATTERIES ACT AS COUNTERWEIGHT
EACH REPLACEMENT BATTERY MUST
WEIGH 120 LBS. (54 Kg.) OR MORE.
066558-001
40
066556-000
44
068639-000
43
067822-001
77
LX31: 066557-060
26
LX41: 066557-057
26
027898-001
25
066562-000
22
062562-002
17
067195-001
14
067365-000
8
067642-012
(Outrigger Units:
067642-010)
11
061205-003
5
060197-000
4
010076-001
2
9
066552-000
12
067638-002
13
067639-001
38
066561-001
6
030768-002
42
064936-099
068641-003
41
066556-001
(Outrigger Units)
46
066551-051
45
066551-003
(Outrigger Units)
47