Apple Macintosh Performa 5400 Series - Manual (Page 134)

5 To see if the card is properly connected, lift it gently. If it resists and stays in place,
it’s connected.
6 If the communication card you installed is an Ethernet card, see if you need to install the
software that comes with it. If you do need to, install it.
7 If you installed an Ethernet card, change the network connection in the Network
control panel.
See the manual that came with the card for more information. For
instructions on how to select a network connection and other information
about using your Macintosh on a network, see the “Networks” topic of
Macintosh Guide, available in the Guide (h) menu.
Closing the computer
1 Slip the base of the logic board into the guide rails inside the computer’s case and swing
the wire handle back into its storage position.
Make sure the logic board slides
into the guides that are on both
sides of the computer’s interior.
Swing the handle up,
into its storage position.
133 Installing an Expansion Card