Infinity pinouts – AEM Infinity Supported Applications - Ford Coyote Engine with Ford Racing Control Pack User Manual
Page 24

24
© 2014 AEM Performance Electronics
Infinity Pinouts
Dedicated
Dedicated and not reconfigurable
Assigned
Assigned but reconfigurable
Available
Available for user setup
Not Applicable
Not used in this configuration
Required
Required for proper function
Infinity
Pin
Infinity Assignment
Pin
Destination
Ford Coyote with FR
Control Pack
Description
Infinity Hardware
Specification
Notes
C1-1
LowsideSwitch_4
Ford Racing
PCM70-51
Intercooler Pump Relay
Control (SCICP PCM
signal)
Lowside switch, 4A max,
NO internal f ly back
diode.
'See Setup Wizard Page 'LowSide
Assignment Tables' f or
conf iguration options. See 2D table
'LS4_Duty [%]' f or activ ation
settings.
C1-2
LowsideSwitch_5
Engine
E-16
Variable Camshaf t
Timing 21 Solenoid
(Driv erside Intake)
Lowside switch, 4A max
with internal f ly back
diode. Inductiv e load
should NOT hav e f ull
time power.
'See Setup Wizard Page 'LowSide
Assignment Tables' f or
conf iguration options. See 2D table
'LS5_Duty [%]' f or activ ation
settings. See Setup Wizard page
'VVC' f or options.
C1-3
LowsideSwitch_6
Engine
E-56
Variable Camshaf t
Timing 12 Solenoid
(Passengerside Exhaust)
Lowside switch, 4A max
with internal f ly back
diode. Inductiv e load
should NOT hav e f ull
time power.
'See Setup Wizard Page 'LowSide
Assignment Tables' f or
conf iguration options. See 2D table
'LS6_Duty [%]' f or activ ation
settings. See Setup Wizard page
'VVC' f or options.
C1-4
UEGO 1 Heat
---
UEGO 1 Heat
Bosch UEGO controller
Lowside switch f or UEGO heater
control. Connect to pin 4 of Bosch
UEGO sensor. NOTE that pin 3 of
the Sensor is heater (+) and must
be power by a f used/switched 12V
supply .
C1-5
UEGO 1 IA
---
UEGO 1 IA
Trim Current signal. Connect to pin
2 of Bosch UEGO sensor.
C1-6
UEGO 1 IP
---
UEGO 1 IP
Pumping Current signal. Connect
to pin 6 of Bosch UEGO sensor.
C1-7
UEGO 1 UN
---
UEGO 1 UN
Nernst Voltage signal. Connect to
pin 1 of Bosch UEGO sensor.
C1-8
UEGO 1 VM
---
UEGO 1 VM
Virtual Ground signal. Connect to
pin 5 of Bosch UEGO sensor.
C1-9
Flash_Enable
---
Flash Enable
10K pulldown
Not usually needed f or automatic
f irmware updates through Inf inity
Tuner. If connection errors occur
during update, connect 12 v olts to
this pin bef ore proceeding with
upgrade. Disconnect the 12 v olts
signal af ter the update.