AEM Infinity Supported Applications - Ford Coyote Engine with Ford Racing Control Pack - Manual (Page 13)

Infinity Supported Application 13
© 2014 AEM Performance Electronics
Ford
Engine
Pin
Wire Color
Ford Coyote
with FR
Control Pack
Description
Infinity
Pin
Infinity
Assignment
Infinity Hardware
Specification
Notes
E-32 Green/White
Digital Cams
Ground (E-
SIGRTN)
C1-20 AGND_1
Dedicated analog
ground
Analog 0–5V sensor
ground
E-33 Y ellow/Grey
Coil on Plug
Assembly 7
(COP7G)
C2-51 Coil 7
25 mA max source
current
0–5V Falling edge
f ire. DO NOT
connect directly to
coil primary . Must
use an ignitor OR
CDI that accepts a
FALLING edge f ire
signal.
E-34 White/Brown
Coil on Plug
Assembly 5
(COP5B)
C1-16 Coil 5
25 mA max source
current
0–5V Falling edge
f ire. DO NOT
connect directly to
coil primary . Must
use an ignitor OR
CDI that accepts a
FALLING edge f ire
signal.
E-35 --- --- --- Not used --- Not used Not used Not used
E-36* Violet/Green
Injector and
Digital Cam
Sensor +12V
Power – Shared
with PCM70-21
C1-61 +12V
12 v olt power f rom
relay
12 v olt power f rom
relay . Relay must be
controlled by +12V
Relay Control signal,
pin C1-29 abov e.
E-37 --- --- --- Not used --- Not used Not used Not used
E-38 --- --- --- Not used --- Not used Not used Not used
E-39 Brown
DBW Negativ e
Slope (TP1)
C1-35 Analog_In_7
12 bit A/D, 100K
pullup to 5V
0–5V analog signal.
Use +5V Out pins as
power supply and
Sensor Ground pins
as the low ref erence.
Do not connect
signals ref erenced to
+12V as this can
permanently damage
the ECU. See the
Setup Wizard Set
Throttle Range page
f or automatic min/
max calibration.
Monitor the Throttle
[%] channel. Also
DB1_TPSA [%] f or
DBW applications.
E-40 --- --- --- Not used --- Not used Not used Not used
E-41 White/Green
Camshaf t
Position Bank 1
(Passenger
Intake)
(CMP11)
C1-22
Camshaf t Position
Sensor 1 Hall
10K pullup to 12V.
Will work with ground
or f loating switches.
See Setup Wizard
page 'Cam/Crank' f or
options.