Brother DCP-4020C - Manual (Page 37)

4 - 2 INITIAL SETUP
Setting the Date and Time
If there is a power failure, you may have to reset the date and time.
All other settings will not be affected.
1
Press Menu/Set , 1 , 2 .
2
Enter the last two digits of the year.
Press
Menu/Set .
3
Enter two digits for the month.
Press
Menu/Set .
(For example, enter 09 for
September, or 10 for October.)
4
Enter two digits for the day.
Press
Menu/Set .
(For example, enter 06).
5
Enter the time in 24-Hour format.
Press
Menu/Set .
(For example, enter 15:25 for 3:25 P.M.)
6
Press Stop/Exit . The LCD now shows the date and time
whenever the DCP is in Standby mode.
GENERAL SETUP
2.DATE/TIME
DATE/TIME
YEAR:20XX
DATE/TIME
MONTH:XX
DATE/TIME
DAY:XX
DATE/TIME
TIME:XX:XX