Barco R9001190 - Manual (Page 39)

9-2
Service Mode
5975398 BARCODATA 3200 110797
PANEL ADJUSTMENT
RED COARSE
FIELD FLICKER
BLACK LEVEL TOP
BLACK LEVEL BOTTOM
GAIN TOP
GAIN BOTTOM
Change color+pattern
with or
Select with or
then
to return.
PRESET INPUT BALANCE
WHITE BALANCE
Select with
to return
Adjust
red with or
blue with or
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE...
Select with or
then
to return.
SERVICE
PANEL ADJUSTMENTS
PRESET INPUT BALANCE
I2C DIAGNOSIS
MORE...
Select with or
then
to return.
I2C DIAGNOSIS
D CA
LCD DRIVER SC76013 E6H # # #
LCD DRIVER SC76013 E8H # # #
LCD DRIVER SC76013 EAH # # #
LCD DRIVER TDA8444 48H # # #
INPUT SELECTORPCF8574A 46H # # #
INPUT SELECTOR PCF8574A7EH # # #
DECODER PCF8574 4EH # # #
DECODER SAA7151B 8AH # # #
DECODER SAA7152 B2H # # #
DECODER SAA7192A E0H # # #
LAMP DRIVER PCF8574A 72H # # #
AUDIO TEA6310V 80H # # #
Select with or
then
to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
LAMP DRIVE MODE
MORE...
Identification
To display the Identification screen, push the control disk up or up to
highlight Identification and press ENTER to display the Identification
screen.
The Identification screen gives an overview of :
- type of projector
- projector address
- software version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
- software version
- Proj. Address : to change the address of the projector, see Change
Projector Address in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in
chapter Installation Set Up.
- Baud rate : transfer speed for communication with a IBM PC (or
compatible) or MAC. The baud rate of the projector must be the same
as the baud rate of the connected computer. When there is a
difference, consult 'Change Baudrate PC' in this chapter.
- Projector Run Time : gives the total run time since the first start up.
All projectors leave the factory with a run time of approximately 24
hours.
- Projector Serial number : indicates the fabrication number of the
projector. This number can be useful when calling for technical
assistance.
- type of projector : BARCODATA 3200