Barco R9001190 - Manual (Page 11)

3-3
Location and Functions of Control
5975398 BARCODATA 3200 110797
11
12
13
14
Terminology
Back light key : When activated, all keys will be lighted up
and visible in the dark.
ADJ. : ADJUST key, to enter the adjustment mode or for
quick exit in the adjustment mode.
Address key (recessed key), to enter the address of the
projector (between 0 and 9). Press the sunk address key
with a pencil, followed by pressing one digit button between
0 and 9.
STBY : Stand by button - to start projection when
the power switch is switched on.
- to switch off the projector
without switching off the power switch.
PAUSE : To stop projection for a short time, press 'PAUSE'.
The image disappears but full power is retained for imme-
diate restarting.
Mute : To stop audio reproduction. Press 'Mute' again to
restart audio reproduction.
Digit buttons : Direct input selection.
Picture controls : Use these buttons to obtain the desired
picture analog level (see also 'Controlling').
PHASE : Used to remove the instability of the image.
TEXT : When adjusting one of the image, e.g. controls during
a meeting, the displayed bar scale can be removed by
pressing 'TEXT' key first. To re-display the bar scale on the
screen, press 'TEXT' key again. 'TEXT' key only active in
operational mode.
1
2
3
4
5
6
7
8
9
10
FREEZ : Press to freeze the projected image.
ENTER : To start up the adjustment mode or to confirm an
adjustment or selection in the adjustment mode.
EXIT : To leave the adjustment mode or to scroll upwards
when in the adjustment mode.
Control disk (on RCU) or '+' and '-' keys (cursor keys):
To make menu selections when in the adjustment mode.
The control disk can move up, down, to the right or to the left.
Comparision between control disk movement and the use of
the cursor keys on the local keypad :
RCU = local keypad
control disk up = '+' key up
control disk down = '-' key down
control disk to the right = '+' key right
control disk to the left = '-' key left
Use the '+' and '-' keys (cursor keys) : to increase or
decrease the analog level of the image controls when they
are first selected.
RC operating indication : Lights up when a button on the
remote control is pressed. (This is a visual indicator to check
the operation of the remote control)
Audio controls : Use these buttons to obtain the desired
audio level (see also 'Controlling').
Help : On line help information
15
16
17