Barco R9001190 - Manual (Page 12)

4-1
Connections
5975398 BARCODATA 3200 110797
ST!"!ÃDI ST!"!ÃPVU 8PHHÃQPSU 6V9DPÃPVU &7 5/
4
ADJ E X IT
STBY T E X T
BRIGHTNESS
- +
- +
- +
- +
SHARPNESS
- +
T IN T
COLOR
CONTRAST
)5((=
0 9
7 8
6 5
4 3
2 1
(17(5
3$86(
- +
3+$6(
+(/3
Projector mode indication
CONTRAST COLOR PHASE
SHARPN TINT BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
CONNECTIONS
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall
outlet. Plug the female power connector into the male connector at
the front of the projector.
Stand by button
Switching on
Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in the
stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button on the local keypad or on the remote
control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode
indication lamp will be green.
This projector may be connected to an IT-power system.
Fuses
Warning
For continued protection against fire hazard :
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Fuse type : T16 AH/250V
100V - 240V
10 - 4 A
60 - 50 Hz
100V - 240V
10 - 4 A
60 - 50 Hz