Toshiba ZL2 - Manual (Page 15)

15
CONNECTING YOUR TV
Engl
ish Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
While all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
If the RED LED is not lit, check that the mains plug is
connected to the power supply and press
1
on the remote
control; it may take a few moments. The GREEN LED will be lit.
To put the television into Standby, press
1
on the remote
control. To view the television, press 1 again. The picture may
take a few seconds to appear.
Press MENU on the remote control to display the menu.
The five initial topics icons will appear. As each symbol is
selected by pressing
C or c on the remote control.
Press
Bb C c
to enter a sub menu and then enter a further
sub menu to see any options.
NOTE: The same menu is displayed in DTV (Digital TV) and
ATV (Analogue TV) modes; however, where some items are
not available in a mode, they will appear grayed out.
To use the option, press
B
and
b
on the remote control to
move up and down and press C or c to select your desired
setting. Follow the on-screen instructions. The functions of
each menu are described in detail throughout the manual.
• To turn on or off the TV, press
!
.
• To alter the volume, press 2 + –.
• To alter the programme position, press p Bb .
• Press MENU and
p Bb
,
2
+ – to control the sound and
picture options.
Press MENU to finish.
• To select an external input, press o until the appropriate
input source is selected.
The Media Player feature provides access to photo, movie and
music files stored on a USB storage device that is connected
via the USB 1 or USB 2 port or on a network device.
The USB 2 port has to be used with a USB HDD (not supplied)
in order to record/playback TV programmes.
NOTE: The USB socket has limited functionality and Toshiba
can take no responsibility for damage to other connected
equipment.
Please always refer to the owner’s manual of the equipment to be
connected for full details.
NOTE: Interactive video games that involve shooting a “gun”
at an on-screen target may not work with this TV.
COMMON INTERFACE
The Common Interface is for a
Conditional Access Module (CAM).
Contact a service provider.
NOTE:
• Software update of a CI Plus CAM may
occur automatically if instigated by the
broadcaster. This could cause the
cancellation of any Reminders/Recordings
during this process.
• Some CI or CI+ CAM may not be supported.
USB 1/USB 2 port
Media Player
USB HDD connection port (USB 2)
Ambient
Light Sensor
Camera Sensor
Control panel
ORANGE LED – Programme timer set (digital only)
RED LED – Programme timer Active (digital only)
RED LED – Standby
GREEN LED – Power on
FOR SERVICE
USE ONLY
Switching on
For energy saving:
We recommend that you use the television with the factory
settings. The factory settings are for energy saving.
Unplugging the mains plug will cut energy use to zero for
all televisions. This is recommended when the television is
not being used for a long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy efficiency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the television into standby mode will reduce
energy consumption, but will still draw some power.
Using the menu system
Using the TV controls and connections