Toshiba Dynadock Wireless U - Manual (Page 50)

50 Using the dynadock™ and Adjusting Settings
Adjusting audio settings
Please note the following:
❖
Interlaced modes are not supported.
❖
The display modes listed above may not be supported by your
monitor, or your monitor may offer additional modes not
supported by the dynadock™. For information on display
modes supported by your monitor, be sure to check the
documentation supplied with your monitor. Select a mode that
both the dynadock™ and the monitor support.
❖
Placing a monitor into an unsupported mode for long periods
can damage it.
❖
If you are using Mirror mode to clone the primary display’s
image on an external monitor, the dynadock™ will attempt to
use the same display mode on the external monitor that you
selected for the primary display. In some cases, however, this
may not be the most appropriate mode for the mirrored desktop
(for example, if the aspect ratio of the displays is not the same).
In these cases, change the primary display mode to match the
optimum display mode for the external monitor.
Adjusting audio settings
Configuring audio ports
You can playback or record audio either through the dynadock’s
audio ports or the docked computer’s audio ports. However, you
cannot use the audio ports on the docked computer and on the
dynadock™ at the same time.
By default, the audio ports on the dynadock™ are automatically
enabled each time you dock the computer. When you undock the
computer, the audio ports on the computer are automatically
re-enabled.
To change the default settings, you may need to manually adjust the
audio settings in Windows
® , as described in this section. For
example, if you want to use the computer’s audio ports while the
computer is docked, you will need to change the default settings.
Configuring audio playback ports
1 Click the TOSHIBA dynadock Utility icon in the System
tray/Notification Area of your Windows
® desktop.
(Sample Image) TOSHIBA dynadock Utility icon