Pioneer CNDV-50MT - Manual (Page 76)

74
App
en
d
ix
set by voice operation, only one route is
calculated.
• Route setting is limited to the range of the disc
in use.
• When the destination is too far, there may be
instances where the route cannot be set. (If
you want to set a long-distance route going
across several areas, set way points along the
way.)
• During voice guidance, turns and junctions
from the motorway are announced. However, if
you pass junctions, turns, and other guide
points in rapid succession, some may not be
announced.
• It is possible that guidance may direct you off a
motorway and then back on again.
• In some cases, the set route may require you to
travel in the opposite direction to your current
heading. In such cases, you are instructed to
turn around, so please turn around safely by
following the actual traffic rules.
• In some cases, guidance may direct you past
your destination and then indicate a U-turn to
get back to it.
• In some cases, a route may begin on the
opposite side of a railway or river from your
actual current location. If this happens, drive
towards your destination for a while, and try
route calculation again.
• In the following cases, the route that passes
through an Area to Avoid may be set:
– when your vehicle is in the Area to Avoid
– when your destination or way points are in
the Area to Avoid
– when it is not possible to avoid doing so
• If a suitable route cannot be set in compliance
with the specified “Detour” distance, or your
preference to avoid motorways, toll roads, ferry
route, the setting or parameter may be ignored.
• When there is a traffic jam ahead, if driving
through the traffic jam is better than taking the
detour, a detour route may not be set.
• There may be instances when the starting
point and the destination point are not on the
highlighted route.
• The number of roundabout exits displayed on
the screen may differ from the actual number
of roads.
Auto Reroute
• Auto Reroute function will work when you
deviate more than 30 m (0.01 mi) from your
route.
• Auto Reroute function does not work in the
following cases:
– when you are too close to your destination
– when your vehicle is not on a street
– when your vehicle is on a ferry
– when driving on a road inside a facility
– when driving on a roundabout
– when driving on the routes are described in
“Roads not Used in Calculations”.
Route highlighting
• Once set, the route is highlighted in bright
green or light blue on the map.
• The immediate vicinity of your starting point
and destination may not be highlighted, and
neither will areas with particularly complex
road layouts. Consequently, the route may
appear to be cut off on the display, but voice
guidance will continue.
Roads not Used in Calculations
Even though displayed onscreen, the following
roads are not included in route calculations.
• Stubble Road
• Walk Way
• Public vehicle only
• Non routable road
Non routable roads (pink colour
road)
Map display is possible, but it cannot be used for
the route calculation. Please review and obey all
local traffic rules along this route. (For your
safety.)
Intersection enlargement
• When “Close-up of Junction” is on, the map
scale increases to show more detail as you
approach an intersection.
• If the intersection is approached in a gentle
curve, the map displayed may differ from the
actual road layout.
MAN-CNDV-50MTP-EN.book Page 74 Friday, April 29, 2005 10:33 AM